I3 The main panel frame assembly
|
English • العربية • български • català • čeština • Deutsch • Ελληνικά • español • فارسی • français • hrvatski • magyar • italiano • română • 日本語 • 한국어 • lietuvių • Nederlands • norsk • polski • português • русский • Türkçe • українська • 中文（中国大陆） • 中文（台灣） • עברית • azərbaycanca • |
Assembly instructions
- Bill of materials
- The main panel frame assembly
- Y-axis assembly
- X-axis assembly
- Z-axis assembly
- Connecting X-axiz and Z-axiz
- Power and LCD assembly
- Extruder assembly
- Heated bed assembly
- power switch and end stops assembly
- Control Board assembly and wiring
- Circuit Diagram
Acrylic Frame Diagram
- 1,front sheet
- 2,left side sheet
- 3,right side sheet
- 4,5,6,7,8,9 Z-axis motor mounting plate
- 10,11 Z axis rod，thread fixed sheet
- 12,13,14 Y axis，back side thread fixed sheet
- 15,16 Y axis motor sea
- 17,18,19 Y axis，front side thread fixed sheet
- 20,21,22 Y axis synchronous belt wheel
- 23,installed below of the heat bed
- 24,25 Z axis the top of Z rod fixed sheet
- 26,Y axis axis synchronous belt，be installed movable heat bed
The main panel frame assembly
Need parts:
- 1,front sheet
- 2,left side sheet
- 3,right side sheet
- 4,5,6,7,8,9 Z-axis motor mounting plate
- 16×M3 NUT
- 16×M3*16 screw
- 16×M3 flat gasket
Step 1
Take the left plate 2 ,and then put into the M3 nut（red mark),Inserted into the left side of the main panel 1 (top panel LCD main circular hole to the right) and then use screw M3 * 16 with tight(red mark).
Step 2
Take the right side sheet3，the same as the above.
Step 3
After do it ,as like this picture.
Step 4
Please put the M3 nut into the left side of the motor fixing plate 4,5,6(red mark),Then fixed with the M3 * 16 screws(red mark).
Step 5
Put the M3 nut inserted into the lower left of the main frame and use M3 * 16 screws to tight.
Step 6
Right side motor mounting platethe same as the above.
