RepRapPro Mendel power supply

This page is under construction

Introduction | Frame assembly | Y axis assembly | X axis assembly | Z axis assembly | Heated bed assembly | Extruder drive assembly | Hot end assembly | Power supply | Wiring | Commissioning | Printing | Multi‑colour/multi‑materials | Colour Printing - Slic3r | Colour Printing - RepRapPro Slicer | Maintenance | Troubleshooting | Improvements

A notice about these instructions!

Since 1st April 2013, the RepRapPro Mendel has been superseded by the RepRapPro Tricolour and Mono Mendel. If you are building the new machine, use the official, and most up to date, instructions on the RepRapPro wiki here

Goal

By the end of this step your power supply should look like this:

Parts

Hardware	Quantity
Fan and heatsink } Next step Wiring