Calibration

Is this part of commissioning? Is this part of Builders/Config/Config Axes?

To calibrate, you will need the following: a Rep(st)rap, a slide caliper, and printing material (ABS, PLA, HDPE, etc).

You will also need this object file to print out.

1. Setup and load your printing material.
2. Print the calibration object.
3. Allow the object to cool.
4. Use the slide caliper to measure each edge and the diagonals.
5. Make a note of each measurement and this will allow you to determine where a problem is IF there is a problem.

With the above measurements, you should be able to determine any alignment issues. The sides should measure withing .5mm of 40mm.

Once you get a simple cube printed adequately, you might consider trying a more difficult object such as the bearing clip 01 for more fine-tuning.