Bukobot

Bukobot (or just Buko) is the 3D printer designed by Deezmaker. The intent of this DIY 3D printer is to create a new generation of Repraps based on this framework. Here are some highlights:

The "Bukobot" low cost Open Source 3D Printer with a roll of Blue ABS filament

• Very easily expandable in any direction
• Designed to handle Dual (or even more in theory) extruders with very little effort
• Very minimal calibration or sdjustments of frame
• No laser cut parts
• No special machined parts (except for maybe an extruder hot end)
• Much lower cost than most Repraps without sacrificing rigidity
• Can be used with nearly any combination of electronics
• Takes advantage of new common materials like UHMW & Sychromesh Cables
• Designed to easily purpose (upgrade) an existing Reprap like the Prusa Mendel and Printrbot