PortaPrusa Build Manual
This is my personal build log
Still To Be Printed Parts
The Repo for the PortaPrusa contains all of the STLs you need in order to make the printer. In addition, it also contains the source blend files.
The following is a list of what still needs to be printed:
| Quantity | STL file | Comments | Picture |
|---|---|---|---|
| 2 | Z-Top.stl | 
| |
| 1 | Z-Bottom-Large.stl | Allows clearance for X-axis motor | 
|
| 1 | Z-Bottom-Small.stl | 
| |
| 1 | X-Big.stl | Holds Motor | 
|
| 1 | X-Small.stl | 
| |
| 1 | Extruder-Main-2.stl | 
| |
| 1 | Extruder-Plug.stl | Retaining plug for bearing | 
|
| 3 | M8-Mount.stl | Retaining block for m8 rod | 
|
| 1 | M8-Mount-Limit.stl | Contains mount for endstop | 
|
| 3 | M4-Mount.stl | Retaining block for m4 rod | 
|
| 1 | Y-Motor.stl | 
| |
| 2 | Bed-Slide.stl | 
| |
| 1 | Bed-Clamp.stl | 
| |
| 2 | Box-Pivot.stl | 
| |
| 2 | Idle-Gear.stl | 
|
Done
| Quantity | STL file | Comments | Picture |
|---|---|---|---|
| 2 | Z-Top.stl | Done! |  
|
| 1 | Z-Bottom-Small.stl | Done! | 
|
| 1 | Extruder-Arm.stl | Done! | 
|
| 1 | Extruder-Clamp.stl | Done! | 
|
| 1 | Extruder-Main-2.stl | Done! | 
|
| 1 | Extruder-Plug.stl | Done! | 
|
| 1 | M4-Mount.stl | One done, 3 to go | 
|
| 1 | Y-Idle.stl | Done! | 
|
| 1 | Bed-BeltMount.stl | Done! | 
|
| 1 | Bed-Clamp.stl | One done, 1 to go | 
|
| 2 | Bed-Slide.stl | Done! |  
|
| 2 | Box-Pivot.stl | One done, 1 to go | 
|
| 1 | Endstop-Mount.stl | Done! | 
|
| 2 | Drive-Gear.stl | Done! |  
|
