Use Sanguish
Release status: working
Description | All in one electronics with Toshiba drivers
|
License | [GPL]
|
Author | |
Contributors | |
Based-on | |
Categories | |
CAD Models | |
External Link | (none)
|
Sanguish Home ----- Build Sanguish ----- Firmware for Sanguish
Warnings !!!
Never insert or remove drivers while the board is powered.
Don't plug or unplug stepper motors while the driver 12V is on. You can plug or unplug steppers if the board is powered as long as the 12V driver relay is off. (As shown by the indicator LED near the relay.)
Be careful when wiring the stepper motor plugs and when plugging them in to avoid shorting one coil to another. The stepper connectors are pretty standard, with one coil on each side of the connector. Be sure that neither of the coils are allowed to span across the middle of the connector. Doing so will likely burn out the driver.
Be careful not to plug the stepper connector in shifted to the side. This will short across the coil outputs and likely burn out the driver. Double check that the connector is centered on the pin header before powering on.
Software Setup
Conections
Older Beta files
File:Sanguish Beta Cheat Sheet.pdf