DarwinPartDevelopment

Darwin Part Development

This interim page is designed to host the developments required to achieve Darwin's replication. Darwin was originally designed with a support material write head in mind. However, it is possible to achieve replication without a support head if some minor design changes are made.

Part	Replicated?	Who	Mod description	Modded STL (attached to page)
Bearing-insert-180-X
Bearing-insert-180-Z
Bearing-insert-360-jam
Bearing-insert-360-run
Bed-clamp
Bed-constraint-bracket
Bed-corner	Y	Vik	Internal flat step bevelled, holes on flange teardropped.	Bed-corner-1.1.stl
Circlip-M8
Corner-bracket
Corner-bracket-vertical-bolt-plug
Diagonal-tie-bracket	Y	Vik	Curved edge replaced with 45 degree step	Diagonal-tie-bracket-1.1.stl
Extruder-quickfit-dock
Extruder-quickfit-latch
Fan-base
Fan-leg
Optoswitch-bracket	Y	eD	M3 chamfer removed. Clamp hole teared.	[[File:DarwinPartDevelopment-Optoswitch-bracket-1.1.stl |thumb]]
PCB-clamp
X-belt-clamp
X-carriage
X-constraint-bracket
X-idler-bracket		Axle hole now teardropped, slightly enlarged slots for nuts under Y belt clamp.	X-idler-bracket-1.1.stl
X-motor-bracket
X-opto-flag
X-PCB-bracket
X-square-jig
XY-pulley-idler		Sloping base flattened, edges of rim bevelled to 45 degrees	XY-pulley-idler-1.1.stl
Y-bearing-housing
Y-belt-clamp	Y	eD	Chamfers removed	[[File:DarwinPartDevelopment-Y-belt-clamp-1.1.stl |thumb]]
Y-motor-bracket
Y-motor-coupling
Y-opto-flag
Z-flag-adjuster-housing
Z-flag-clamp
Z-flag-slider
Z-motor-bracket
Z-motor-coupling
Z-opto-flag
Z-studding-tie
Z-toothed-pulley-rim	Y	Vik	Rim thickened for strength. In thick layers, only one or two were deposited on the original.	Z-toothed-pulley-rim-1.1.stl

-- Main.EdSells - 16 Nov 2007