FoldaRap Y-motor AzteegX1 120W
Redirect page
Redirect to:
>>Back to FoldaRap_Build_Manual#Y-motor
The 120W power supply is a generic power supply, but with a low profile (34mm).
- Power supply to male plug : 1 green wire 18WG of 15cm, one end with ferule, the other end just stripped
- Switch to power supply : 1 red and 1 black wire 18AWG of 15cm, one end with ferule, the other end just stripped
- Switch to male plug : 1 red wire of 6cm, 1 black of 9cm 18AWG, both ends with ferule
- board to power supply : 8 cm red/black wires
- It is maybe a good time to check if the stepper drivers are correctly set (see Pololu_stepper_driver_board and SureStep82 user guide)