Talk:Mendel heated bed
Revision as of 09:02, 26 May 2010 by GilesBathgate (talk | contribs) (Created page with '"To access D15 you need to solder a pin to the gate of the left-hand power MOSFET on the controller board as shown here at C: " Could the circuit or firmware not be slightly mod…')
"To access D15 you need to solder a pin to the gate of the left-hand power MOSFET on the controller board as shown here at C: "
Could the circuit or firmware not be slightly modified to allow you to connect the output of the extruder MOSFET be connected to the input of the Heated bed MOSFET, this would then save you having to solder a pin onto the gate.
