Talk:DremelFlexShaftHolder
merging
There are multiple, different milling toolheads that should have different pages describing that one specific toolhead in the section Development:Toolheads
There can be a central page about PCB-milling and one about 3D-milling but they use different mills, have a different creator, can be attached to different cartesian bots and a different version-history.
Merging them only creates confusion.
Marcus --MarcusWolschon 12:57, 5 April 2010 (UTC)
- Please forgive my confusion.
- In general I agree that each distinct toolhead should have its own distinct page.
- However, from what little I could glean from reading the DremelFlexShaftHolder and Flex Shaft milling-toolhead articles,
- both toolheads are the http://www.thingiverse.com/thing:1832 toolhead and so both pages are about exactly the same toolhead, and so therefore should be merged.
- Dear reader, if you know which of these 2 articles is *not* the http://www.thingiverse.com/thing:1832 toolhead, would you please edit that article to point out what it is instead, and perhaps mention some specific difference between the two toolheads.
- Thank you. --DavidCary 06:00, 7 April 2010 (UTC)
- How did you get the idea that both are thing1883? DremelFlexShaftHolder states that it is thing#1703 and Flex Shaft milling-toolhead states that it is thing#1832 . --MarcusWolschon 07:18, 7 April 2010 (UTC)