User contributions
(newest | oldest) View (newer 20 | older 20) (20 | 50 | 100 | 250 | 500)
- 20:57, 12 April 2015 (diff | hist) . . (+256) . . G-code (→M540: Enable/Disable "Stop SD Print on Endstop Hit")
- 20:54, 12 April 2015 (diff | hist) . . (+314) . . G-code (→M226: Wait for pin state)
- 20:43, 12 April 2015 (diff | hist) . . (+260) . . G-code (→M150: Set display color)
- 20:42, 12 April 2015 (diff | hist) . . (+317) . . G-code (→M120: Enable endstop detection)
- 20:39, 12 April 2015 (diff | hist) . . (+382) . . G-code (→M48: Measure Z-Probe repeatability)
- 20:37, 12 April 2015 (diff | hist) . . (+608) . . G-code (→M-commands: some Marlin additions)
- 19:27, 12 April 2015 (diff | hist) . . (+175) . . G-code (→Checking)
- 18:25, 12 April 2015 (diff | hist) . . (+770) . . G-code (→G-commands: some Marlin additions)
- 09:14, 8 April 2015 (diff | hist) . . (-48) . . G-code (→M103: Turn all extruders off, Extruder Retraction: no seperate heading needed if meaning of the command is the same)
- 09:09, 8 April 2015 (diff | hist) . . (-34) . . G-code (→M102: Turn extruder 1 on (Reverse): no separate heading needed if meaning for this command is the same)
- 09:08, 8 April 2015 (diff | hist) . . (-50) . . G-code (→M101: Turn extruder 1 on (Forward), Undo Retraction: no separate heading needed if meaning for this command is the same)
- 16:45, 7 April 2015 (diff | hist) . . (+375) . . G-code (→M commands: move EEPROM commands to this section)
- 15:42, 7 April 2015 (diff | hist) . . (-6) . . G-code (→Fields: could also be inch or mm³ depending on mode or settings)
- 15:38, 7 April 2015 (diff | hist) . . (+411) . . G-code (→Fields: described in more detail)
- 15:02, 6 April 2015 (diff | hist) . . (+51) . . m G-code (→M commands)
- 14:57, 6 April 2015 (diff | hist) . . (+6) . . G-code (→G commands)
- 14:51, 6 April 2015 (diff | hist) . . (+445) . . G-code (→M commands)
- 14:10, 6 April 2015 (diff | hist) . . (-7) . . G-code (→G commands)
- 14:04, 6 April 2015 (diff | hist) . . (+2) . . m G-code (→Buffering)
- 13:50, 6 April 2015 (diff | hist) . . (+220) . . N User:Stefan8410 (Created page with "Hello Everybody! I am a software engineer, and I live in Vienna, Austria. Since February 2015, I am interested in 3D printing and G coding. My first 3D printer that I built ...") (current)
(newest | oldest) View (newer 20 | older 20) (20 | 50 | 100 | 250 | 500)