ReplicatorG-Skeinforge-RAMPS

I built a RepRap Mendel with Wade's Extruder.

Here will be the place with the tweaks I did to get it going with ReplicatorG.

Firmware used: Teacup

First of all:

Be sure baudrates match:

Config in replicatorg/machines/ directory comes here:

Modifs made to config.h.ramps (not complete yet)

StepX 1/16 StepY 1/16 StepZ 1/16 StepE 1/4

Turned on XON/OFF protocol, seems to work better.

(more to be added)

Skeinforge settings:

Activate dimension Set to Relative

ReplicatorG settings:

Prferences: Generate separate Z steps (not sure this necessary)