Prusa Mendel thereprapkitstore

This page is about the Prusa Mendel version sold by thereprapkitstore.co.uk.

Detailed Assembly Instructions can be found in this reprap-wiki: ABSPrusa.

High resolution photos are published on the seller's page.

construction is discussed in the RepRap Forum

batch sales

Batch 1:

Batch 2: This batch was shiped with a one week delay and it did only contain the mechanics. Three weeks later electronics and belts were shipped. Instead of a Melzi board, a Sanguinololu board with an additional SD-plugin was shipped. A forum thread about this delay can be found here[1]

Batch 3:

Batch 4 (PRE ORDER for DISPATCH on May 31st):

difference to the standard Mendel

M8 lock washer instead of plain washers are used.

A smaller M8 Mudguard washer is used, allowing easier jigging.

The inside jiging length is 273mm instead of 234mm. (The 290mm outside frame jiging length is the same.)

people having such a Mendel

roland: forum - homepage: www.reprob.org - speaking: german, english - location: Germany --Roland 07:09, 22 May 2012 (UTC)