Measurement/Circle Test
Revision as of 13:57, 21 November 2009 by Sebastien Bailard (talk | contribs) (Still thinking this out.)
Contents
Introduction
Materials
- 2x Inline Skate Bearings
- 1x Digital Caliper
- (Contact electronics - optional)
Method
- Bolt down one bearing, the Bed Bearing the upper face of your print bed.
- Attach the other bearing, the Test Bearing to the lower end of your extruder, or using TestBearingMountingHardware.
- Using the software, move the Test Bearing so that is roughly lies above t
Analysis
Using your favorite spreadsheet (table showing mockup)