IOBox
Revision as of 16:46, 12 February 2006 by VikOlliver (talk | contribs) (version migrated from twiki)
IOBox
The IOBox is a simple test tool that acts like any other RepRap networked component and allows direct control of I/O lines from the host PC. it can be used with most of the hardware modules, but is probably most applicable to the Stepper Controller board.
Pinouts
- B1, B2: Comms
- B0, B3-B7: Outputs
- A0-A7: Inputs
Commands
- 0: Get version
- 1: Set outputs
- 2: Get inputs
Firmware
The compiled firmware is in the files section below. The source is in CVS at reprap/firmware/iobox
The device resides at address 50 on the network.
Examples
Set all outputs to ON
Read inputs (and display as decimal value)
For more details, see the Poke tool documentation.
-- Main.SimonMcAuliffe - 10 Feb 2006