FoldaRap power-supplies

>>Back to Y-motor or Underplate section

120W "led" (FoldaRap 1.1 and 2)

Low Profile 120W (FoldaRap 1.1 and 2)

The 120W power supply is a generic power supply, but with a low profile (34mm).

• Power supply to male plug : 1 green wire 18WG of 15cm, one end with ferule, the other end just stripped
• Switch to power supply : 1 red and 1 black wire 18AWG of 15cm, one end with ferule, the other end just stripped
• Switch to male plug : 1 red wire of 6cm, 1 black of 9cm 18AWG, both ends with ferule
• board to power supply : 8 cm red/black wires

• 
• 
• 
• 

  mine wasn't labelled, but the order is usually Live/Neutral/Ground

Low Profile 240W (FoldaRap 1)

The 240W power supply is a TXH240 [1]. It was replaced by a 120W power supply after we realized the first one was a little overkill (and costly, the 120W is ten times cheaper).

• Power supply to male plug : 1 green wire 18WG of 35cm, one end with ferule, the other end just stripped
• Switch to power supply : 1 red and 1 black wire 18AWG of 35cm, one end with ferule, the other end just stripped
• board to power supply : 8 cm red/black wires

<videoflash>_tXWGjJq0zM|320|240</videoflash>

• Bolt the PSU on the plate, with a washer between the psu and the plate