VertX
Release status: concept
Description | a direct-drive extruder/x-carriage for the V9 hotend (for the moment)
|
License | |
Author | |
Contributors | |
Based-on | |
Categories | Development
|
CAD Models | |
External Link |
Contents
Inspiration
- EMAKER_Huxley
- Huxley-eg
- The Gen X Skb-Kiparis remix I discovered on this thread : http://forums.reprap.org/read.php?94,84403,93044#msg-93044
- Orca and the v9
I wanted to design a vertical carriage with linear bearings, but mixed with the V9 (direct drive, no damn PTFE, no mouting block) to make it even simpler. And thus came this "carriage-struder".
Benefits
- only 2 pieces (in replacement of 5-10 pieces, compared to the original sells carriage or the prusa or the open-x-carriage, plus an extruder)
- with LM8UU (locked by zip-tie)
- active cooling with a little fan, mounted on only one point to just rotate it if needed to access at the inside/unmount the hotend
- a very compact/accessible extruder ^^
- "Double pulley driven" x-carriage (inspired from http://forums.reprap.org/read.php?2,85051)
- Bearing holders tend less to snap, thanks to the printing orientation
- the whole x-axis may be assembled without removing any Z-rods (except to put the linear bearing on it)
Mendel
V0.3a
<flickr>6060884422|left</flickr>
V0.2
And the x-ends that will have to be tested too. The spacing between the Z rods are for a Sells Mendel, to replace the classic x-axis (don't checked for a Prusa but if different that may not be difficult to adapt and re-export)
V0.2.2
V0.2.1
V0.1 (not tested yet)
When looking back at the eMaker, maybe two LM8UU can be enough ?
Files
FILE ID# | TYPE | DESCRIPTION | AVAILABLE FORMATS | CREATED/BY |
---|---|---|---|---|
v0.1 | .STL | x-carriage-body | (save as) | --Emmanuel |
v0.1 | .STL | x-carriage-idler | (save as) | --Emmanuel |
Also on Thingiverse (but I prefer the wiki to manage the versions, I tried github but maybe not for me yet)
Orca
V1b
Not tested yet and could be refined (rounded edges, some details, inverting the bearing parts that drive the belt to hang it close to the linear bearing and thus make it more compact)
But it's supposed to be a drop-in replacement of the actual x-carriage :
FILE ID# | TYPE | DESCRIPTION | AVAILABLE FORMATS | CREATED/BY |
---|---|---|---|---|
v1b | .STL | x-carriage-struder_body | (save as) | --Emmanuel |
v0.1 | .STL | x-carriage-struder_idler | (save as) | --Emmanuel |