Adrian's Geared Extruder
Revision as of 12:55, 21 March 2010 by Adrianbowyer (talk | contribs)
This page is a development stub. Please enhance this page by adding information, cad files, nice big images, and well structured data!
Adrian's Geared Extruder
Release status: Experimental
Description | Geared Nema17 Extruder Driver
|
License | GPL
|
Author | |
Contributors | |
Based-on | |
Categories | |
CAD Models | |
External Link |
Introduction
I wanted to design a universal extruder driver that could
- Be bolted to the X carriage of Mendel and run as a normal extruder,
- Be mounted somewhere at the side and drive a Bowden extruder, and
- Be mounted somewhere at the side and drive a Bowden paste extruder, as outlined here.
This is my first hack at a solution.
This design was made to extend Wade's neat geared extruder that you can find here. (Wade's design was based on my original here.)
<videoflash type="vimeo">10269267|320|240</videoflash>
Features
- 55:11 gear ratio means that the motor runs on very low current
- No hobbing or knurling to make the filament driver
- Torque transmitted using a wing nut, giving low stress on reprapped gears
- Uses the same 624 bearing as the rest of RepRap Mendel.