Videos
Contents
Adrian and Ed's RepRap Introduction
<videoflash type="vimeo">5202148</videoflash>
Erik's RepRap Commercial
<videoflash type="youtube">cRH3RQ2F4Wk</videoflash>
Ericsson Multimedia Video on Adrian
<videoflash type="youtube">xvXHORiDHYM</videoflash>
RepRap Instructional Videos
Throughout the documentation on this wiki there are a number of instructional videos. They ara also gathered together here all in one place.
The video below is an introduction to the Mendel design:
<videoflash type="vimeo">6865848</videoflash>
Video on the key mechanical concepts behind Mendel's axes:
<videoflash type="vimeo">6982104</videoflash>
The following video shows the runs of all the wires in RepRap Mendel:
<videoflash type="vimeo">8397407</videoflash>
Videos on splitting the timing belts that drive Mendel's axes:
<videoflash type="vimeo">7027330</videoflash>
Video of Mendel's Y-axis working:
<videoflash type="blip">AYH27g8A</videoflash>
Here's a video showing how to unload a print that has been made, and then set things up for a new one (including mildly amusing Adrian-confusion when the USB port lock has not been cleared). This is for a RepRap with an unheated bed:
<videoflash type="vimeo">11618621</videoflash>
This video shows how to maintain flatness in a RepRap be that is heated. The blue tape on the tray is Scotch painter's masking tape 2090, which can be obtained at most hardware shops:
<videoflash type="vimeo">14317374</videoflash>
This video shows how to tidy up parts post-reprapping:
<videoflash type="vimeo">14492980</videoflash>