Hardware Store (HS) Extruder
This is a variation on the extruder design (sans heater at the moment) that can be made from elements found at a common hardware store. Total cost for the extruder without the drive motor or any electronics is approximately $20.
Bill of Materials
# | Item | Dimensions |
---|---|---|
1 | Flat Bar Stock | 1/8" x 1/2" x 8" |
2 | U-Bolt | 1-1/4" x 1" |
2 | Skate Bearings | 608 |
1 | Vynil Aquarium Hose | 1" |
2 | Angle Bracket | 2" x 2" |
1 | Bolt | 1/4-20 x 1/2" |
1 | Nut | 1/4-20 |
1 | Shoulder Bolt | M6 x 5 |
Tension Bearing Bracket
<More to come!>