PCB adaptions for Mendel
Revision as of 18:06, 19 November 2009 by Adrianbowyer (talk | contribs) (New page: ===Replacing the connectors on the stepper driver boards=== These connectors are low-cost, as is the cabling for them. But they are not very neat. To replace them do the following. [[I...)
Replacing the connectors on the stepper driver boards
These connectors are low-cost, as is the cabling for them. But they are not very neat. To replace them do the following.
Use a pair of tweezers to pull the gold-plated connectors inside the RJ45 shell and push them up through the top. Then pull them out from the top and straighten them out.