BlogPhotosFromVik

Vik's Blog Photos

I need somewhere to put them that has non-crippled bandwidth, right?

-- Main.VikOlliver - 03 Jun 2006

• A single layer test extrusion done with a 0.5mm nozzle.:
  

File:BlogPhotosFromVik-test extrusion using 0.5mm nozzle sml.jpg

• Polymorph feedstock jamming up and wrapping around the threaded rod.:
  

• Two layers of crosshatch and their parent 0.8mm nozzle.:
  

File:BlogPhotosFromVik-two layer output with 08mm nozzle sml.jpg

• [[File:BlogPhotosFromVik-mov02395.mpg: MPEG of deposition using 0.8mm nozzle @ 140C with 1.1mm x 0.8mm layers|thumb]]

• Still from mov02395.mpg:
  

• Small shot of hexagon deposited in mov02395.mpg:
  

• mov02395.mpg 2nd layer close-up of head:
  

• This is the first complete 5mm sample "Produced", and its attendant Tower of Ooze:
  

• Shot of defect in 20mm hexagonal print test.:
  

• The test hex, made using Adrians code, shown from above.:
  

• The test hex, made using Adrians code, shown from above.: