I3 Heated bed assembly
|
English • العربية • български • català • čeština • Deutsch • Ελληνικά • español • فارسی • français • hrvatski • magyar • italiano • română • 日本語 • 한국어 • lietuvių • Nederlands • norsk • polski • português • русский • Türkçe • українська • 中文（中国大陆） • 中文（台灣） • עברית • azərbaycanca • |
Need parts:
- 1×Heated bed mount(23 part)
- 1×Y-axis belt holder(26 part)
- 4×SCS8UU linear bearings
- 1×Belt（650mm)
- 16×M4 * 10 screws
- 4×M3 nut
- 2×M3 * 16 screws
- 2×M3 * 20 screw
- 10×M3 flat gasket
- 4×M3 * 25 countersunk screws
- 4×8 * 6 spring
SCS8UU linear bearings assembly
Loosen the smooth rod fixing plate of Y-axis, out smooth rod 10cm, then put on SCS8UU，at the end reset smooth bar fixing plate, and tighten.
Y-axis belt holder assembly
Step 1
Insert the M3*20 screw,then tighten with M3 nuts.
Step 2
Put the M3 nut into 26 part.
Step 3
Screw toward the hexagonal hole.
Step 4
With the two pieces M3 * 16 screws to tight the plate.
