Wilson TS Bill of Materials
The parts list below is the default for Wilson TS, which uses all metric components and has a 210mm x 210mm x 200mm (XYZ) build volume.
There is an OpenOffice spreedsheet in the github repository which will assist in generating a BOM for other build volumes.
You can easily use other lengths of rods and extrusions if more convenient to source. I don't recommend trying to extend the Z axis up a lot though, because the stress on the lower frame mounts may become too much.
Parts List
Mechanical parts
Printed Parts
All other parts
Everything Else | ||
NEMA17 Stepper motor | 5 | |
Hot End (J Head) | 1 | |
MDF board (6mm thick) | 1 | 230mm by 230m |
MK2 Heat bed | 1 | |
Glass bed | 1 | 3mm borosilicate |
Controller (Mega/RAMPS, Rambo, etc | 1 | |
Endstop (limit) switch | 3 | |
LM8UU Linear bearing | 12 | |
608ZZ roller bearing | 4 | |
624 roller bearing | 2 | |
5mm to 5mm shaft couplers | 2 | Can also use 3/16" ID vinyl tubing |
40mm x 40mm x 10mm fan | 1 | |
80mm x 80mm fan | 1 | |
Miniature zip ties | 20 | |
Extruder idler springs | 2 | High tension |
Bed leveling springs | 4 | Lower tension |
Power Supply | 1 | |
Hot end | 1 | JHead |
Hobbed bolt | 1 | airwolf3d! |