Hot End Comparison
Revision as of 18:13, 17 March 2014 by Ohioplastics (talk | contribs)
Hot end designers are encouraged to add their hot ends in the table below, as well as start a wiki page where lists of suppliers can be put.
- this table is for hot ends only, it is not a supplier list, add your supplier list to the wiki page associated with the hot end
Hotend name | Designer | Mount type | Direct/Bowden | Build Material | Filament Sizes (mm) | Nozzle Sizes (mm) | license | Wikipage/Link | Reviews & Additional notes |
---|---|---|---|---|---|---|---|---|---|
E3D - V5 | Sanjay | Modified Groove Mount | Both | All Metal | 1.75/3 | 0.25/0.3/0.35/0.4/0.6/0.8 | CC BY-NC-SA 3.0 | Wiki Page, E3D Online | Forum Discussion |
Aluhotend V5B | Thejollygrimreaper | 4.6mm Groove Mount (same as jhead) | direct (bowden with printed adapter) | stainless/aluminium/brass/ptfe liner | 1.75 | 0.3/0.5 | NC (to be revised) | Wiki Page, Webstore | - |
J-Head Mk V | Brian Reifsnyder | Groove Mount | Direct; Bowden with Adapter | PEEK/PTFE/Metal | 1.75/3 | 0.35/0.45/0.5 | GPL | Wiki Page, hotends.com | - |
Merlin | Srek (Björn Marl) | M10/J-Head Adapter | Both | PEEK/PTFE/Brass | 1.75/3 | 0.2/0.3/0.5 | CERN OHL 1.2 | Merlin Blog | - |
Argento | jameghino (Javier Ameghino) | Groove Mount same as jhead | Both | stainless steel/aluminum/brass/PTFE liner | 1.75 | 0.4 | CC BY-NC-SA 4.0 | jfa3D.com.ar | - |
J-Head Lite | Ohio Plastics | 3/8" Groove Mount | direct (bowden with printed adapter) | PTFE Holder, Stainless Steel Barell, Aluminum Heater Block, Brass Nozzle | 1.75 | .4, .35, .3, .25, .2 | Creative Commons Attribution Share Alike | Thingiverse, Ebay | - |
sample entry | sample | sample | sample | sample | sample | sample | sample | sample | sample |
See Also
Forum discussion: Best hot end