User:McNeight
Current Setup
Hardware
Clonedel plastic parts from Metrix Create:Space with SAE / Imperial vitamins, resulting in a near duplicate of an SAE Prusa Mendel with a Wade's Geared Extruder
Electronics
Arduino Mega 2560 attached to a RepRap Arduino Mega Pololu Shield (RAMPS) from UltiMachine. The hot end was purchased as a kit from MakerGear
Firmware
Alternating between the johnnyr branch of Tonokip and the main branch of Teacup Firmware
Software
ReplicatorG 0024 and dev version of repsnapper
Important Measurements
For use with firmware as well as software:
- X & Y axes
- 8 tooth pulley using XL drive belt
- Z axis
- 5/16-18 threaded rod
- Extruder
- 3mm feedstock
- 0.50 mm nozzle