RUG/Czech Republic
Komunita
Pro výměnu zkušeností a vzájemnou pomoc bylo založeno komunitní forum na adrese http://3dforum.cz
Translation
Where to get parts
Local Shops may be better or worse than buying from online retailers. This depends on your local shops and what you're getting. Stepper motors you'll want to get online, steel rod - perhaps not. Fasteners, it depends. You may want to check your yellow pages to look these up, as opposed to online.
Plastic parts
- [Fugazza] prints
- [Forrest] printing all parts
- [Prusajr] prints
- [Miroslav Batek] has printing Mendel too, dunno if he prints parts.
- [Brmlab hackerspace] has printing Prusa Mendel.
- [3dfab.cz] ABS Filaments and more
- Laboratoř 3D tisku na FIT ČVUT (3dprint.fit.cvut.cz) prints
Electronics
- Charlie's 3D Technologies - RAMPS 1.4
- HW Kitchen - Arduino a shieldy (Šenov)
- SnailInstruments - RAMPS 1.4 a ovladače krokových motorů (Pololu 1182) (Beroun)
- CzechDuino - Levné Arduino desky a příslušenství (Plzeň)
Motors
All local stuff is extreamly pricey. Zapp is best, but from UK tho :-/
Microcon - aktuálně (2013/03) zřejmě nejpříznivější český prodejce. V akci pod kódem "HQ" mají následující dva motory:
- SX17-1005 (Nema 17, 0,50 Nm) 249,- Kč bez DPH
- SX17-0905 (Nema 17, 0,55 Nm) 330,- Kč bez DPH
Mechanical stuff
- [Ferona] carries all and is in Prague. Local shops should be fine too.
- [Rousek] sell almost all kinds of nuts, screws, washers for good price.
- [FABORY] in stores sell in small amounts, you can get good discount if you will register.
Belts
Tyma has belts and pulleys. Pricier then online sources tho.
U Megadyne jsem si objednal řemeny přes kontaktní formulář za tyto ceny:
5T5-840 Ozubený řemen PU....83,-Kč/Ks bez DPH 5T5-900 Ozubený řemen PU....86,50 Kč/Ks bez DPH
Pikron - 5T5 - kolem 95,-Kč/Ks bez DPH (2012)
Haberkorn-Ulmer - 5T5 - 85 až 90,-Kč/Ks bez DPH (2012)
Meetings
- BrmLab hackerspace every tuesday from 6PM. (Prague)
Nearby Robot Hobby Clubs
Keyword searches to help you find Geek Groups Meetups
(keywords: your town, artist-run center, artbot, barcamp, dorkbot, experimental media, ham radio, linux, arduino, blender, circuit bending, RC aircraft, rocketry, cnc, etc.) This will require a few google searches, where you enter your town and one of the keywords above into the following string: "Your Town" keyword (meetup OR meeting OR group OR club OR society OR workshop OR hobby) [dorkbot.org] [www.arduino.cc]
- Local/Nearest FabLab or Techshop,
- Community College with a Machine Shop that people can use?
- CNC Group Meetups on cnczone.com or otherwise
[www.google.ca]