I3 X axis assembly
|
English • العربية • български • català • čeština • Deutsch • Ελληνικά • español • فارسی • français • hrvatski • magyar • italiano • română • 日本語 • 한국어 • lietuvių • Nederlands • norsk • polski • português • русский • Türkçe • українська • 中文（中国大陆） • 中文（台灣） • עברית • azərbaycanca • |
Need Parts
- 1. 2×M8*370 mm Axis
- 2,3,4,5. 4×RP plastic parts
- 6. 8×8UU Bearing
- 7. 2×M5 NUT
- 8. 1×Pulley
- 9. 2×Single Bearing
- 10.8×M3flat gasket
- 11.4×M3 LOCK NUT
- 12.3×M3*12 screw
- 13.2×M3*20 Countersunk head
- 14.1×M3*25 screw
- 15.2×M3 NUT 2×M3*6 blunt end headless screws
- 16.1×Belt
- 17.8×Tie
- 18.1×NEMA 17
RP Plastic Part
Step 1
You need the 5mm dill, Set counterclockwise rotation and drill progressively and carefully along the axis.
Step 2
You need 3mm drill.Set counterclockwise rotation and drill progressively and carefully along the axis.
Step 3
X End Idler & X End Motor assembly
Step 1
You need the 15 parts.First put the M3 nut in the hole, then tighten the M3*6 blunt end headless screws.
Step 2
You need the 9,10,11,14 parts.Please assemble in accordance with the picture.
Step 3
You need the 7 parts.Please install the M5 nut to plastic parts (red mark).
Step 4
Push two LM8UU linear bearings in the X End Idler and two LM8UU linear bearings in the X End Motor. They can be pushed with hands but you can use a rubber mallet carefully if necessary.
