This special page shows all uploaded files.
|10:28, 9 March 2017||No image available.png (file)||5 KB||Reverted to version as of 14:19, 30 May 2013||12|
|08:42, 22 May 2011||Lasercut huxley gear reassembled.png (file)||1.21 MB||Here's the result of re-centering the washer on the gear. Used some little wood screws to replace the nail as I had nothing so tiny to hammer in.||1|
|08:29, 22 May 2011||Washer separated from gear.png (file)||694 KB||After 10 minutes of solvent and knife actions, taddaa ! Nearly clean separation of the 2 pieces forming the big lasercut gear of my Techzone Huxley extruder. Although a bit of sanding might be enough, to be sure to work on plane surfaces, I'll do the plac||1|
|07:42, 22 May 2011||Extruder gear not round turning.avi (file)||2.33 MB||Test run of my extruder gear prior fixing. Note on the right the outer circle of the gear moving up and down while it turns.||1|
|07:29, 22 May 2011||Mounting extruder gear with extra washers.png (file)||1.15 MB||Added some washers between the gear and the support so that the filament path is aligned with the filed and hobbed hole on the bolt.||1|
|07:01, 22 May 2011||Lasercut gear non centered hex hole.png (file)||1.12 MB||The big extruder lasercut gear as provided by Techzone in their Huxley kit. Note the little "washer" with an hex hole was glued a bit aside regarding the gear round center hole.||1|
|06:39, 22 May 2011||2 holes in a bolt.png (file)||721 KB||Wade extruder bolt, filed and hobbed at 2 locations, as provided in my TechZone Huxley kit.||1|