Farynozzle1.0

From RepRap
(Redirected from Farynozzle1.0/es)
Jump to: navigation, search
Crystal Clear action run.png
Farynozzle-1.0

Release status: Working

Farynozzle-1.0.jpg
Description
Open source hot end
License
 Creative Commons By-SA 3.0 Unported
Author
Contributors
Based-on
Categories
CAD Models
External Link


Description

The Farynozzle hot end is a Budaschnozzle based hot end, consisting of several pieces in various matherials detailed below. This hotend can work continuously for tenths of hours at up to 250ºC. It is very reliable and have been tested for printing with ABS and PLA.

Specs

Heater

By default, the Farynozzle comes with a Vishay RWM06226R80JA15E1 (6.8ohm) -> ~21W @12V. It has also been tested with a 40W heat cartridge succesfully.

Thermistor

The default thermistor used in the Farynozzle is a Honeywell 135-104LAG-J01. It is a 100k thermistor compatible with most firmwares. Can operate up to 300ºC with a 10% tolerance.

Parts

Farynozzle vertical.jpg

From up to down:

  • Printable mount
  • Wooden laser cut mount
  • PTFE liner
  • Hexagonal spacers
  • Aluminium heatsink
  • PEEK isolator
  • Steel mount
  • Wood mount
  • Screws
  • Aluminum thread
  • Aluminum resistor block
  • Nozzle

Planes

The planes are freely available on github here

Where to buy?

Farynozzles are produced in Zaragoza (Spain) in small amounts. Buy it in Farynozzle.com


Farynozzle parts 1.jpg Farynozzle parts 2.jpg Farynozzle parts 3.jpg Farynozzle parts 4.jpg Farynozzle parts 5.jpg Farynozzle parts 6.jpg Farynozzle parts 7.jpg

Printing with FaryNozzle1.0 (video)

<videoflash type="youtube">2QbR87NMY5I</videoflash>