Wade's Geared Extruder

From RepRap
Revision as of 16:38, 29 April 2010 by Casainho (talk | contribs) (Added link for pictures of other users that builded this extruder :-))
Jump to: navigation, search
Crystal Clear action run.png
Wade's Geared Extruder

Release status: Stable

Geared Nema 17 Extruder
CAD Models
External Link

Characteristics/advantages of this extruder:

  • extrude/print at high speed;
  • good for use with a low torque Nema 17 motor;
  • no need to glue the PTFE barrel;
  • no need to use expensive metal gears;
  • no need to use expensive and complex tools - just one hand drill, a file and a M3 tap;
  • no need to make splines on motor shaft;
  • no need to do two precision flats on motor shaft;

See here pictures of it, from the users that builded it.

Mechanical Construction


  • 3 X 608 bearings;
  • 1 X M8X50 bolt;
  • 1 X M8 nut;
  • 4 X M8 washers;
  • 1 X M8X20 piece of bar, threaded bar or a bolt;
  • 4 X M4X40 bolts;
  • 4 X M4 nuts;
  • 4 X M4 washers;
  • 4 X M3X10 bolts;
  • 2 X M3X35 bolts;
  • 2 X M3 nuts;
  • 8 X M3 washers;

How to build it

I used a hand drill and a file to cut the slot, then hobbed it with an M3 tap mounted in the drill, using bearings mounted in a vise to let the bolt spin - see the next videos:

M8 1.jpg

M8 2.jpg

M8 2inside.jpg

M8 2gears.jpg

So far so good!

Here's the test jig:

M8 test jig.jpg

This extruder hit 16 kg - here's the results: M8 shoulder bolt - 7.0kg, adjusted tension, new springs - 11.0 kg,

Tightened springs, 3 trials:

15.5 kg, 16.5 kg, 15.25 kg

The final failure mode was the stepper running in reverse, as opposed to the filament slipping. That's quite promising.

3D CAD Files

Here's the design files for the latest version:

Finally, here's a spreadsheet to help calculate the proper feedrates: media:feedrates.ods | media:feedrates.xls