Template:RepRapPro mini extruder drive assembly
Revision as of 13:58, 4 January 2013 by Adrianbowyer (talk | contribs) (Created page with 'You will need one drive for each colour/material that your Mendel will print, up to a maximum of three. This section describes the parts for one drive. {| border="1" style="tex…')
You will need one drive for each colour/material that your Mendel will print, up to a maximum of three. This section describes the parts for one drive.
| |
| Item | Quantity |
| Large internal gear (printed) | 1 |
| Small push-fit gear (printed) | 1 |
| Main block (printed) | 1 |
| Tongue (printed) | 1 |
| PCB clips (printed) | 2 |
| Slotted custom PCB clip (printed) | 1 |
| M3 nuts | 6 |
| M3 nyloc nuts | 2 |
| 30mm M3 caps | 2 |
| 35mm M3 caps | 1 |
| 25mm M3 caps | 1 |
| 25mm M3 any-flat-head screw | 1 |
| 20mm M3 caps | 3 |
| 12mm M3 caps | 1 |
| M3 spring washer | 1 |
| M3 washers | 15 |
| 3mm bearings 10mm OD x 4mm thick | 3 |
| 8mm M3 hobbed drive | 1 |
| Short NEMA 17 motor | 1 |
