Talk:RepRapPro Huxley y axis assembly
Revision as of 09:49, 17 April 2012 by Mark Benson (talk | contribs)
My y axis axis halves are too thick for a 16mm and two washers. Anybody else have this problem? --Busterdog 02:31, 16 January 2012 (UTC) Sorry missed the note about leaving off the washers. --Busterdog 02:48, 16 January 2012 (UTC)
The instructions show the belt clamps on the top of the sled. When setup like this (on my machine) the belt raises up and tightens towards either end of travel. I moved the clamps to the bottom of the sled (flip the clamps over, put the screws through from the flat side of the clamp and put the nuts on the top of the sled.). This way the belt runs parallel along the entire length of travel. --Mark Benson 13:49, 17 April 2012 (UTC)
