Talk:RAMPS 1.4

From RepRap
Revision as of 14:20, 18 November 2014 by NeoTheFox (talk | contribs)
Jump to: navigation, search

In the Power Supply With/without diode sections, you mean D1 right? — Weasel 05:22, 4 December 2011 (UTC)

power terminal

The leads of the power terminal push against MEGA's power supply socket. You can't really fit the boards together

And did it really have to be SMT? -- Soleld 12:13, 13 March 2012 (UTC)

D1 D2 Diode

The information entered is confusing, please add a picture representing all three configurations I.E. D1 with D2 / NO D1 with D2 / D1 with no D2 / NO D1 with NO D@

(a better design for this should be made to prevent damage to electronics)

Wiring BlueTooth

I think there is a mistake in the picture : http://www.reprap.org/wiki/File:BT_Connection_RAMPS1.4.png The two resistor should be connected between GND and +5V and not with RxD.

would you like to add this link http://www.reprap.org/wiki/Jy-mcu to the bt discussion on page?

would you like to add this link http://www.reprap.org/wiki/Jy-mcu to the bt discussion on page?

http://www.reprap.org/wiki/Jy-mcu

it allows the arduino to directly setup the bt device in most cases.

The Picture of a fully loaded Ramps 1.4 is missing

The Picture is missing of the Ramps 1.4 board with all of the stepper drivers fitted unless I missed seeing it..?

There are text warnings on the cct diagram about plugging the step-stick/Pololu drivers in the right way round but not one single picture showing "Them plugged in the right way round"

The jumper selector section is wrong

The jumper section for drivers is wrong - it can vary for drivers, like DRV8825. Section should mention this.