Stepper motor controller SNAP protocol
This is now in a fairly usable state.
When programmed into a PIC16F628 (default), the pinouts are:
Device pintouts
- Sync bus connection
- Not used
- Not used
- Not used
- Ground
- Not used
- RX
- TX
- Not used
- Stepper output 1
- Stepper output 2
- Stepper output 3
- Stepper output 4
- +5V
- Not used
- Not used
- Minimum optointerrupter input
- Maximum optointerrupter input
The software is currently set up to use a unipolar stepper motor (or motor with compatible sequencing).
-- Main.SimonMcAuliffe - 30 Dec 2005