RUG/Pennsylvania/State College/Printers/PSU Unit Yellow

---

Introduction

This page is dedicated to the PSU Unit Yellow 3D printer. This unit will follow the design of the Open Hybrid Mendel developed by students of the EDSGN 497 class at The Pennsylvania State University.

Operating Specifications

Operating Specifications
Name	Status	Design	Electronics	Firmware	Extruder	Running Temp	Comments
Yellow	Running	Ohm	RAMPS	???	???	202 degrees C

Builders

Spring 2013 Yellow team:

Btz5006, Djl5217, Vatlark, MarkKeller22

State College RepRap Users Group S.C.R.U.G. Main · The Make Space · Intercollegiate Future Society · Wiki Help