RUG/Pennsylvania/State College/Printers/PSU Unit Yellow

From RepRap
Revision as of 00:40, 25 January 2013 by Btz5006 (talk | contribs) (Introduction)
Jump to: navigation, search
PSU unit Yellow.png


This page is dedicated to the PSU Unit Yellow 3D printer. This unit will follow the design of the Open Hybrid Mendel developed by students of the EDSGN 497 class at The Pennsylvania State University.

Operating Specifications

Operating Specifications
Name Status Design Electronics Firmware Extruder Running Temp Comments
Yellow Yellow Running Ohm RAMPS ??? ??? 202 degrees C

Works in Progress


Spring 2013 Yellow team:

Btz5006, Djl5217, Vatlark, MarkKeller22

State College RepRap Users Group
S.C.R.U.G. Main · The Make Space · Intercollegiate Future Society · Wiki Help
Herringbone glowing2.jpg