RUG/Pennsylvania/State College/Printers/PSU Unit Orange
Revision as of 00:31, 28 April 2013 by Xiaomo Zhang (talk | contribs)
This page is for information about the PSU Unit Orange, which is under construction. This unit will follow the design of the Ohm. All of the printable parts will be printed in PLA and assembled.
Contents
Operating Specifications
| Operating Specifications | |||||||
|---|---|---|---|---|---|---|---|
| Name | Status | Design | Electronics | Firmware | Extruder | Temperature | Comments |
Orange 
|
Not Working | Ohm | RAMPS | ??? | ??? | ??? | Not assembled. |
Works in Progress
Builders
PSU Unit Black - Current Condition
As of 4/27/2013. Mcdonalds is working well. Two fans need to be on when the printing is running. One is the large cooling fan. It is used to cool the extruded plastic in case of its warping. Another smaller fan is used to cool down the y motor. The only issue about Mcdonalds is the flatness of the bed. The bed is slightly higher toward positive y.
| ||||||||||
