RUG/Pennsylvania/State College/Printers/PSU [email protected]
[email protected] is now fully operational in all axes. The next step in its developement will now be to undergo print testing, or alternatively, convert the electronics to RAMPS1.4 with Marlin Firmware now that all electrical components have been confirmed opperational.
Pennsylvania State University (PSU) [email protected] is in operational mode and continue to be in diagnostic form. Within next week, we have an idea how to approaching for the future project.
Fab2home current status
The [email protected] were completed builded by previous owner of the machine. I did check every part to make sure that were properly align and secure. [fabahome.org [email protected]] as a guide, the [email protected] were mechanically build as instructed.
We were fortune enough to have all the working electronic kits and installed as instructed. Microcontroller for [email protected] model 1:Microcontroller Olimex Philip LPC-H2148 (under ARM) Apparently, we are missing the JTAG cord which is important for flashing the microcontroller. I believe we are specifically looking for OpenOCD with firmware v4. However, the board were flash for firmware v3. Firmware module
Currently, I am using [email protected] v.23 made by cornell university for mendel 1 and driver [email protected] Both are portable loaded into the computer and are seem to be communicate with the [email protected]
- Future project:
- Alernative software or improving coding
Currently we have Acrylic Winsor Blue available for part to print. More to come on order and check out vendors for harware and material
Currently, [email protected] machine has a working X axis and Z axis. Y axis does not function very well because there is something wrong with the motor not being adjusted. Also, the X axis seem to be driven itself after the program are close, which is not good. With in this week, we can expected to get the [email protected] ready for future project.