RUG/Pennsylvania/State College/Printers/PSU Big Red

From RepRap
Revision as of 01:52, 5 December 2013 by Dgdwazzaaa (talk | contribs) (Table colors are now consistent.)
Jump to: navigation, search
BigRed2.jpg
BigRedLogo2.png
Big Red
Color: Red
Extruder: .35mm
Temperature: 200C


This page is for information about the PSU Unit Big Red. This printer is designed to be an Open Hybrid Mendel, or OHM for short.

Log

Date Modification / Problem
09/04/2013 Tightened the Z-Axis/Motor holder (electronics side)

Operating Specifications

Design Ohm
Electronics Rambo
Firmware Marlin
Extruder

Gallery

About this printer

This printer was printed and built by the following three indiviuals on the build team:

We originally hoped to print all pieces in red, however due to the limited supply of red plastic we were forced to choose a different color. This particular class has been producing 3D printers from scratch. Most of the printers assembled are OHM printer models but each semester parts for the printers are being innovated and changed. For example, a few structural pieces for our printer have been tweaked to better accommodate the use of our printers. Also for our end stops we are transitioning from light sensors to touch sensors. Another change is we are changing the electronics system of our printers to the RAMBo electronics.