RUG/Pennsylvania/State College/Electronics/Comparison

From RepRap
Revision as of 13:23, 30 November 2011 by Glenn (talk | contribs) (+ Category:RUG, Pennsylvania, State College)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Sanguinololu

Pros

    • 7-30v
  • 2 thermistor
  • will do prussa
  • 2 n mos for extruder or for the bed
  • uart1
  • i2c
  • spi
  • 1 pwm
  • 5 analog i/o
  • mostly through hold components

Neutral

  • sdcard support is talked about but isn’t really visible
  • usbttl needed
  • prusa ok

Cons

  • 4 popolu board’s stepper only

Generation 3 Electronics

Generation 7 Electronics

Pros

  • slightly faster 25%
  • can run heated bed off board
  • usbttl needed
  • 2 thermistor 1 for tip 1 for bed
  • prusa ok

Cons

  • also 4 boards 1/16 steps


Ramps

Prices & Details

Pros

  • allows additional arduino shields, like Ethernet...
  • not really self etch able
  • i2c
  • spi
  • 5 polo boards
  • heated bed control 11 amp fuse
  • prusa ok
  • no usb adapter needed

Cons