PCB Design
The following will provide instructions as to how to use your RepRap as a way to draw the RAMPS motherboard with a 5th stepper motor motherboard.
Required Materials
- Copper Clad board (6.5" x 4.5") - Ferric Chloride Chemical Etchant - Permanent Marker - PCB Drill Bits - Acetone
Set-Up Instructions
1. Make the pen holder that attaches to the carriage of RepRap (see link)
2. Download the g-code version of the RAMPS motherboard. One has the typical 4 stepper motor model, the other is a 5 stepper motor model.