PCB Design

The following will provide instructions as to how to use your RepRap as a way to draw the RAMPS motherboard with a 5th stepper motor motherboard.

Required Materials

Copper Clad board (6.5" x 4.5") Ferric Chloride Chemical Etchant Permanent Marker PCB Drill Bits Acetone

Set-Up Instructions

1. Make the pen holder that attaches to the carriage of RepRap (see link)

2. Download the g-code version of the RAMPS motherboard. One has the typical 4 stepper motor model, the other is a 5 stepper motor model.