MendelMax

From RepRap
Revision as of 22:03, 21 October 2011 by Kludgineer (talk | contribs)
Jump to: navigation, search

MendelMax is a new RepRap 3d printer designed by Maxbots. It is a true reprap, using printed brackets, but instead of using threaded rod for the structural elements it uses inexpensive aluminum extrusions. This gives a huge increase in rigidity for a minimal extra cost (Self sourcing will cost about $50 more than a standard Prusa when purchased from the recommended suppliers). The required extrusions are available world wide from a variety of suppliers.

In addition to greatly increased rigidity, this design is faster to assemble (probably 4 hours for most users), a larger (and more easily scaled) build area, easier to print, and easier to hack on.

Full assembly instructions and parts lists are available at http://www.mendelmax.com.