Clone wars:Impresora Death Star

From RepRap
Revision as of 09:46, 25 January 2015 by Vertikar (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
Language Issue/s on this page!
This article needs translation into English.

This article is written in a language other than English. As it is intended for readers from the RepRap community, Alternate translations are encouraged. In particular, an English translation is required. Please see the layout and translations of the http://www.reprap.org/wiki/Main_Page as an example of how this should be achieved. in short you should follow these conventions: If your page is called XXXXX, and is not in english, please do the following:

  • add a languages header to the page, using {{Languages}}
  • copy the non-english content from the "primary" page to the appropriate language page. For example, if your content is in Deutsch, move the content from XXXXX to XXXXX/de
  • revise the original XXXXX page to be english-only, except for the "Languages" header.



Reprap-gen1.png

Introduction

Death Star is my first 3D Printer. Iteration is a Prusa Mendel 1. The construction process was long. Even had virtually no experience in the assembly and it was printing slowly parts Mother and once had and the parts needed for the next step was buying the necessary equipment (rather me ahead to buy the hehehe material) for further assembly. It's been pretty I started printing my first piece and have many memories ... few hours Friday afternoon after work looking like Mother inverted printed parts Death Star, while chatting with the people who were there, teachers, students ... Thanks to the help of everyone who helped me and especially Objuan! Thank you very much !!!

Méritos

  • Icono premio.png El primogénito: Es el primer clon Hijo de MADRE :-)
  • Icono premio.png Es el segundo Jedi-Master. El segundo clon en imprimir un juego completo de la Prusa 2

Autor

Ficha

Clon-Deathstar 2012-01-07 1-r2.jpg
  • Nombre: Death Star
  • Familia: Prusa_Mendel_(iteration_1)
  • Generación: 1
  • Material: Plástico ABS
  • Color: Blanco, Naranja, Amarillo y negro
  • Impresora Progenitora: MADRE
  • Electrónica: RAMPS 1.3 + Arduino Mega 2560
  • Firmware: Sprinter
  • Extrusor: Wade's extruder (plástico de 3mm)
  • Hot-End: Arcol v3.0. (Aguja de 0.5mm)
  • Nacimiento: 06/Enero/2012 (primera pieza impresa), a las 22h
  • Constructor: Fernando Salceda (Klonando)
Deathstar.png

Fotos


Vídeos

300|250</videoflash> 300|250</videoflash> 300|250</videoflash>
300|250</videoflash> 300|250</videoflash> 300|250</videoflash>
300|250</videoflash> 300|250</videoflash> 300|250</videoflash>
300|250</videoflash> 300|250</videoflash> 300|250</videoflash>
300|250</videoflash> 300|250</videoflash> 300|250</videoflash>

Enlaces

Clone-Wars-logo.png

Proyecto Clone Wars