BIQ Opto Endstop

From RepRap
Revision as of 10:43, 8 December 2011 by Bodgeit (talk | contribs)
Jump to: navigation, search
Crystal Clear action run.png
BIQ Opto Endstop

Release status: working

BIQOptoEndstop.jpg
Description
Revision 0.1
License
CC BY-NC-SA 3.0
Author
Contributors
Based-on
[[]]
Categories
CAD Models
Eagle
External Link


BIQOptoendstop.jpg

Introduction

RepRap compatible Opto Endstop using an Opto End stop with a 0.5mm beam slightly smaller than the HB102 beam wdith of 0.8mm.

The opening of the interrupter is 5mm allowing for a 3mm black perspex interrupter tag designed for use on Huxley Seedling but can be used on All RepRaps.

The output of all three versions is an Open collector active High signal.

Active high means a 1 is made when the end-stop is triggered.

Project goal was to Design:

A small low cost PCB < £1.00 for 3 bare PCBS.

Low cost of components.

With a smaller beam to break.

Wider opening for a 3mm interrupter and little more clearance.

Three circuit build configurations. ECO, standard, and Illuminated.

Reprap Standard mounting centres. (holes)

Master Schematic of board

CCT BiQoptofull.png

Master CCT of the PCB.

Three circuits

ECO Schematic

(easy to build Discreet components)

CCT BiQoptoeco.png

Standard Schematic

(more difficult to build Discreet components with one Surface mount resistor)

CCT BiQoptostd.png

Illuminated Schematic

(difficult to build Discreet components with two Surface mount resistors)

CCT BiQoptoillu.png


To be updated with files and build pictures.

BIQOptoendstop2.jpg.jpg BIQOptoendstop3.jpg.jpg